HP D2D2502i Manuel d'utilisateur télécharger pdf (Page 71)

7. Select a Target Appliance from the list and click Next.

NOTE: If you want to select an appliance that is not yet on the list, click Add Target Appliance.

Enter the Target Appliance IP Address or fully qualified domain name. The default values for

the Command and Data Protocol Port Numbers are usually acceptable, but may be edited if

there is a conflict. (If replication needs to take place through a firewall, the network

administrator will need to open (TCP) ports 9387 (Command protocol) and 9388 (Data

protocol) to allow the replication traffic to pass to and from the HP StoreOnce Backup Systems.)

Click Add Target Appliance.

8. The wizard then moves to the Select Target Share step. Select a share on the target appliance

and click Next.

NOTE: If you need to create a new share on the target appliance, click Create New Target

Share. Set up the details as you would normally do when creating a new share. You cannot

create a new target share if the appliance to be used as the target has Replication Source

Permissions enabled.

9. Give the Share Mapping a name and click Next.

NAS Mappings (Replication) 71

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 177 178

Pas de commentaire

HP D2D2502i Manuel d'utilisateur Page 71