HP 35s Scientific Calculator Manuel d'utilisateur télécharger pdf (Page 106)

6-4 Entering and Evaluating Equations

Entering Equations into the Equation List

The equation list is a collection of equations you enter. The list is saved in the

calculator's memory. Each equation you enter is automatically saved in the equation

list.

To enter an equation:

You can make an equation as long as you want – it is limited only by the amount of

available memory.

1. Make sure the calculator is in its normal operating mode, usually with a

number in the display. For example, you can't be viewing the catalog of

variables or programs.

2. Press

. The EQN annunciator shows that Equation mode is active, and

an entry from the equation list is displayed.

3. Start typing the equation. The previous display is replaced by the equation

you're entering — the previous equation isn't affected. If you make a mistake,

press

 or : as required.

4. Press  to terminate the equation and see it in the display. The equation

is automatically saved in the equation list — right after the entry that was

displayed when you started typing. (If you press

 instead, the equation is

saved, but Equation mode is turned off.)

Equations can contain variables, numbers, vectors, functions, and parentheses —

they're described in the following topics. The example that follows illustrates these

elements.

Variables in Equations

You can use any of the calculator's variables in an equation: A through Z,(I) and

(J). You can use each variable as many times as you want.(For information about (I)

and(J), see "Indirectly Addressing Variables and Labels" in chapter 14.)

To enter a variable in an equation, press

 variable. When you press , the

A..Z annunciator shows that you can press a variable key to enter its name in the

equation.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 381 382

Pas de commentaire

HP 35s Scientific Calculator Manuel d'utilisateur Page 106