HP 35s Scientific Calculator Manuel d'utilisateur télécharger pdf (Page 230)

14-20 Programming Techniques

  

 

  

  

  

 

Press

L, then press  Z to see that the loop–control

number is now 11.0100.

Indirectly Addressing Variables and Labels

Indirect addressing is a technique used in advanced programming to specify a

variable or label without specifying beforehand exactly which one. This is

determined when the program runs, so it depends on the intermediate results (or

input) of the program.

Indirect addressing uses four different keys: 0, 7, 1 , and A.

These keys are active for many functions that take A through Z as variables or

labels.

 I and J are variables whose contents can refer to another variable. It holds a

number just like any other variable (A through Z).

 (I) and (J) are programming functions that directs, "Use the number in I or J to

determine which variable or label to address."

This is an indirect address. (A through Z are direct addresses.)

Both 0 and 7 are used together to create an indirect address and this applies to

both 1 and A as well.

By itself, (I) or (J) is either undefined (no number in (I) or (J)) or uncontrolled (using

whatever number happens to be left over in I or J).

The Variables "I" and "J"

You can store, recall, and manipulate the contents of I or J just as you can the

contents of other variables. You can even solve for I,J and integrate using I or J . The

functions listed below can use variable "i"(the variable J is the same).

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 381 382

Pas de commentaire

HP 35s Scientific Calculator Manuel d'utilisateur Page 230