HP 35s Scientific Calculator Manuel d'utilisateur télécharger pdf (Page 203)

Simple Programming 13-21

3. Moving the cursor”_” and press  repeatedly to delete the unwanted

number or function, then retype the rest of the program line. (After pressing

, Undo function is active)

Notice:

1. When the cursor is active in the program line, Ø or × key will be

disabled.

2. When you are editing a program line (cursor active), and the program line is

empty, using

 will have no effect. If you want to erase the program line,

press

 and the program line will be erased.

3. You can use

Õ and Ö key to review long program lines and

without editing it.

4. In ALG mode,

can not be used as a function, it is used to validate a

program line.

5. An equation can be editing in any mode no matter which mode it was

entered in.

Program Memory

Viewing Program Memory

Pressing   toggles the calculator into and out of program entry (PRGM

annunciator on, program lines displayed). When Program–entry mode is active, the

contents of program memory are displayed.

Program memory starts at  . The list of program lines is circular, so you

can wrap the program pointer from the bottom to the top and reverse. While

program entry is active, there are four ways to change the program pointer (the

displayed line):



× and Ø allows you to move from label to label. If no labels

are defined, It will move to the top or bottom of the program.

 To move more than one line at a time ("scrolling"), continue to hold the

× key.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 381 382

Pas de commentaire

HP 35s Scientific Calculator Manuel d'utilisateur Page 203