Hp Integrity rx4610 Server Manuel d'utilisateur télécharger pdf (Page 31)

Chapter 3: Installing Fans and Power Supplies

Installing a Power Supply

The power supply bay should not be vacant for more than five minutes when server power is on.

Disruption of the airflow may cause system cooling to fall below acceptable levels. To install the new

power supply, complete the following procedure:

1. Remove the new power supply from the protective packaging, and place it on an antistatic

surface.

2. Record the model and serial numbers of the power supply in your equipment log.

3. With the handle in the open position (pulled down), slide the replacement power supply into

the power supply bay until it stops.

4. Rotate the handle up and in to lock the power supply into place.

5. Check the new power supply LEDs to verify proper functioning.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 200 201

Pas de commentaire

Hp Integrity rx4610 Server Manuel d'utilisateur Page 31