Hp Integrity rx4610 Server Manuel d'utilisateur télécharger pdf (Page 54)

Chapter 6: Installing an Additional Processor

Figure 6-1. System Board Set

Removing the CPU Thermal Dummy

CPU thermal dummies must be installed where a processor is absent to properly direct cooling

airflow. Therefore, the CPU thermal dummy must be removed before installing an additional

processor.

Complete the following procedure to remove the CPU thermal dummy:

1. Observe the safety and ESD precautions at the beginning of this chapter.

2. Remove the Processor/Memory Complex as described in “Removing the Processor/Memory

Complex” in Chapter 5.

3. Orient the complex such that you have access to the surface from which you are removing

processors or CPU thermal dummies.

4. Loosen the four captive screws that secure the triple-beam to the sides of the

Processor/Memory Complex.

5. Remove the sheet metal baffle located to the front of the processors or CPU thermal dummies

in the Processor/Memory Complex. To remove the baffle, press the flexible retaining tabs in

as you slide the baffle out. You need this sheet metal baffle out of the way to access some of

the captive screws in the next step.

6. Loosen the captive screws in the top of the triple-beam and lift it up and away from the

Processor/Memory Complex.

7. Lift the blanks out of the complex.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 200 201

Pas de commentaire

Hp Integrity rx4610 Server Manuel d'utilisateur Page 54