Hp Integrity rx4610 Server Manuel d'utilisateur télécharger pdf (Page 57)

Chapter 6: Installing an Additional Processor

11. Place the triple beam into position by lowering it down over the processors/power pod or the

CPU thermal dummy.

12. Connect the Y-cable to each power pod.

Figure 6-4. Placing the Triple Beam Over the Processors

13. Secure the triple beam into place by tightening the top captive screws and then the four

thumbscrews on the end of the beam.

14. Insert the sheet metal baffle at the front of the processors or CPU thermal dummies in the

Processor/Memory Complex. To insert the baffle, press the flexible retaining tabs in as you

slide the baffle into place.

15. Be sure to close the plastic latch to secure the Processor/Memory Complex halves.

16. Insert the Processor/Memory Complex into the chassis as described in “Installing the

Processor/Memory Complex” in Chapter 5.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 200 201

Pas de commentaire

Hp Integrity rx4610 Server Manuel d'utilisateur Page 57