HP 100BaseT Guide de l'utilisateur télécharger pdf (Page 113)

HP 100Base-T Hubs Installation and Reference Guide

Hardware Reference 5-9

Partition - A port is temporarily partitioned when a line error

or too many collisions are detected on the attached collision

domain. While automatically partitioned, the port continues to

receive data from the segment. However, data is not

transmitted onto the segment. When the problem is corrected

or a valid data packet is received through the port, it is

automatically reconnected. When partitioning occurs, the

port’s

3DUWLWLRQ'LVDEOH LED will be continually lit. Otherwise,

this LED should be OFF.

Disable - Disabling a port is the same as manually partitioning it,

except that you must also manually reconnect it. For example,

to prevent a certain device from accessing the network or to

reduce network traffic you may opt to disable the port. No

incoming packet transmission can occur on a disabled port.

Ports can be disabled/enabled using the VT-100 console

interface.

The Partition/Disable LEDs are also used as diagnostic LEDs.

Please refer to

Diagnostic

Test Indicators

for more information.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 156 157

Pas de commentaire

HP 100BaseT Guide de l'utilisateur Page 113