HP 100BaseT Guide de l'utilisateur Page 97

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 157
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 96
HP 100Base-T Hubs Installation and Reference Guide
4-38 Configuring the System
Xmodem Download
Enter Xmodem Download under the Download menu to
download firmware to the hub. The Xmodem protocol is used
to transfer binary files over a PC connection (i.e., using
terminal emulation or modem access software).
Specify the download mode and select Start Download. Open
the file transfer utility in your terminal emulation or modem
access program, specify the filename, and then start file
transfer. When transferring files from your computer, be sure
you specify “Send” or “Upload” file. The file should be an
AdvanceStack Hub-12TXM *.bin file from HP; otherwise the
agent will not accept it. Also be sure that you have already set
the required bootup option for the target hub under the Hub
Configuration menu.
File transfer status is indicated by messages at the bottom of the
screen. Firmware is first loaded into a temporary buffer. If you
selected download for permanent use, it will then be transferred
to nonvolatile memory. After you finish transferring the firmware,
the agent will be reset and you will have to log back into the
configuration program again. The following screen shows an
example of the Xmodem Download menu.
Vue de la page 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 156 157

Commentaires sur ces manuels

Pas de commentaire