HP 100BaseT Guide de l'utilisateur télécharger pdf (Page 5)

Quick Installation iii

Quick Installation

Hewlett-Packard’s Hub-12TX/Hub-12TXM models each contain

12 Fast Ethernet 100Base-TX, RJ-45 (MDI-X) ports, one MDI

cascade port, and one Expansion Slot for an optional connection

using 10/100TX and 100FX Switch Port Module. The Hub-24TX

contains 24 Fast Ethernet 100Base-TX, RJ-45 (MDI-X) ports,

and one MDI cascade port.

The design built into the front display panel and configuration

options provides a friendly interface that simplifies installation

and network troubleshooting. If you are already familiar with

basic network operations, you should be able to install this hub

as described below:

1. Unpack the HP 100Base-T unit.

2. Find a location close to the network devices you need to

connect, and within easy reach of an electrical outlet.

3. Mount the hub on a desktop or any other flat surface. If you

are installing multiple hubs, you can stack them on top of

each other (after attaching the foot pads), or install them in a

standard EIA 19-inch rack. Note that these hubs do not

support wall mounting. See Chapter 2 for more details.

4. Connect any devices that use a standard 100Base-TX RJ-45

connector to the RJ-45 (MDI-X) station ports (for example,

a workstation or server). Use 100

W Category 5 unshielded

twisted-pair (UTP) or 100

W shielded twisted-pair (STP)

cable. Also be sure that the length of any twisted-pair

connection does not exceed 100 meters. (Refer to Chapter

2 for a more detailed description of calculating the maximum

cable length permitted between two end nodes.)

5. If you are stacking multiple hubs, connect the Stacking

Cable between the Stacking Ports (

Out and In), found on the

rear panel of the hub, on adjacent hubs. Run a simple chain

starting at the

Out port on the first managed hub (Hub-

1 2 3 4 5 6 7 8 9 10 ... 156 157

Pas de commentaire

HP 100BaseT Guide de l'utilisateur Page 5