HP 10BASE-T Guide de l'utilisateur télécharger pdf (Page 15)

5. Repeat step 1 through 4 for each device to receive redundant power.

With four devices connected to the RPS, your rack would appear

similar to the following illustration:

3. Verify the RPS’s Operation

To verify the operation of the RPS, follow these steps:

1. Connect both of the included RPS AC power cords from the

RPS AC Power connector to a reliable AC power source. HP

recommends two separate AC power lines for added redundancy.

2. Check the LEDs on the RPS’s front panel:

During Power-On: All LEDs are on for one second.

After Power-On: AC Power LEDs are on.

Connected DC Power Output LEDs are on.

Fan is on.

If the Fault LED is on, see the troubleshooting table on page 12.

Hub-24

Hub-48

RPS

RPS AC power cords connected to an

operating AC power source

Installation Summary

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Pas de commentaire

HP 10BASE-T Guide de l'utilisateur Page 15