HP J Class 3 - For Visualization Center Manuel de service télécharger pdf (Page 111)

Chapter 5 111

Boot Console Handler

Searching for Bootable Media

To list all devices that contain bootable media, follow the directions in the section

“Accessing the Boot Console Handler” found in this chapter, and type the following at the

prompt:

Main Menu: Enter command > search ipl [Enter]

The search command searches all buses. The search may turn up more devices than there

are lines on the display. If you are using a text terminal, you can control the progress of the

search from the terminal’s keyboard by doing any of the following:

• To temporarily suspend the search, press [Ctrl]-[S].

• To continue the search, press [Ctrl]-[Q].

• To halt the search, press any other key.

These ﬂow-control commands do not work with a bit-mapped display, but such a display

can show more than forty lines of text, so you are unlikely to need them.

To search for devices of just one type that actually contain bootable media, follow the

directions in the section “Accessing the Boot Console Handler” found in this chapter, and

then type the following at the prompt:

Main Menu: Enter command > search ipl

device_type

[Enter]

where

device_type

is one of the following:

• fwscsi is the internal, Wide LVD (Low Voltage Differential) SCSI bus.

• scsi is the external, SE/LVD ( Single-Ended/Low-Voltage Differential) SCSI bus.

• lan is all connections to the built-in LAN.

• ide is the built-in CD ROM drive.

• pci

is an optional SCSI interface in slot number

For more information about the search command, type the following at the prompt:

Main Menu: Enter command > help search [Enter]

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 147 148

Pas de commentaire

HP J Class 3 - For Visualization Center Manuel de service Page 111