HP J Class 3 - For Visualization Center Manuel de service télécharger pdf (Page 146)

146 Appendix B

SCSI Connections

Assigning SCSI Device IDs

2. Here is the breakdown of the hardware path:

SCSI device 10/0/15/0.2.0

SCSI 10/0/15/0.2.0

SCSI ID 2 10/0/15/0.2.0

NOTE

Do not use SCSI device ID 7 for any device. It is reserved for the built-in SCSI

bus controller.

Assigning Internal SCSI Device IDs

You can determine which LVD SCSI devices are currently in use by looking under the H/W

Path heading in the output from the ioscan command discussed previously. The entry

10/0/15/1 is the built-in LVD SCSI bus. For devices connected to the built-in LVD SCSI bus,

such as disks, the number between the two decimals and after the third “/” in the hardware

path speciﬁes the SCSI ID for that device. For example, a hardware path of 10/0/15/1.5.0

speciﬁes a LVD SCSI device at SCSI ID 5. Here is the breakdown of the hardware path:

SCSI device10/0/15/1.5.0

LVD SCSI10/0/15/1.5.0

SCSI ID 510/0/15/1.5.0

CAUTION

Do not use SCSI device ID 7 for any device. It is reserved for the built-in SCSI

bus controller.

1 2 ... 141 142 143 144 145 146 147 148

Pas de commentaire

HP J Class 3 - For Visualization Center Manuel de service Page 146