HP J Class 3 - For Visualization Center Manuel de service télécharger pdf (Page 114)

114 Chapter5

Boot Console Handler

Displaying and Setting Paths

To set a system path to a new value, follow the directions in the section “Accessing the Boot

Console Handler” found in this chapter, and type the following at the prompt:

Main Menu: Enter command > path

path_type path

[Enter]

where

path_type

is one of the path types listed in Table 5-1 and

path

is the speciﬁcation of

the path in Mnemonic Style Notation (as described in Table 5-2). For example, to set the

primary boot path to a SCSI disk with an ID of 6.0, follow the directions in “Accessing the

Boot Console Handler” on, and then type the following at the prompt:

Main Menu: Enter command > path pri scsi.6.0 [Enter]

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 147 148

Pas de commentaire

HP J Class 3 - For Visualization Center Manuel de service Page 114