HP J Class 3 - For Visualization Center Manuel de service télécharger pdf (Page 125)

Chapter 5 125

Boot Console Handler

Displaying and Setting Fastboot Mode

When fastboot is enabled (set to on), the workstation does a quick check of the memory

and skips some processor self tests during its power-on self tests. This enables the

workstation to complete its boot process quicker. The default factory setting is for

fastboot to be enabled (set to on).

When fastboot is disabled (set to off), more extensive memory and processor testing is

performed during the selftests, causing the boot process to take longer.

If you are experiencing difﬁculty in booting the workstation, set fastboot to off and

reboot the system. The more extensive testing may reveal the error condition.

To display the status of fastboot, type the following:

Configuration Menu: Enter command > fastboot [Enter]

To disable fastboot, type the following:

Configuration Menu: Enter command > fastboot off [Enter]

To enable fastboot, type the following:

Configuration Menu: Enter command > fastboot on [Enter]

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 147 148

Pas de commentaire

HP J Class 3 - For Visualization Center Manuel de service Page 125