HP NetServer LP 2000r Guide de l'utilisateur télécharger pdf (Page 112)

Chapter 12 Troubleshooting

106

Figure 12-3. Battery on System Board

7. Insert the new battery with the positive sign (+) facing up. Push the battery

down into the socket.

The battery should snap into place. Ensure the spring latch holds the

battery firmly.

8. Replace the PCI card cage, processor cooling fan, and cover.

9. Power on the Netserver.

10. Press <F2> to run the Setup Utility and reset the CMOS settings. Refer to

“Setup (BIOS) Utility” in Chapter 10, "Configuring the HP Netserver."

Problems Running the Setup Utility

If you cannot run the Setup Utility, the HP Netserver's configuration in CMOS

memory may have become corrupt. The only way to recover from a corrupted

configuration is to clear it. Refer to "Clearing the CMOS Configuration," earlier in

this chapter.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 135 136

Pas de commentaire

HP NetServer LP 2000r Guide de l'utilisateur Page 112