HP NetServer LP 2000r Guide de l'utilisateur télécharger pdf (Page 54)

Chapter 6 Installing an Additional Processor

7. Open the ZIF (Zero Insertion Force) lever. Then lift the terminator out of

the socket and place it on anti-static surface or container. See Figure 6-2.

To open the ZIF lever, pull the lever out away from the ZIF socket and

raise it 90

° to the system board.

ZIF Lever

Terminator

Processor

Socket

Figure 6-2. Removing the Terminator

NOTE Keep the terminator for future use. The terminator must be

installed in the secondary processor socket when only one

processor is used or the HP Netserver will not operate properly.

8. Align the second processor over the empty processor socket, as shown in

Figure 6-3.

CAUTION Ensure that you the align pin-1 of the processor with pin-1 of

the processor socket or pin damage will occur.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 135 136

Pas de commentaire

HP NetServer LP 2000r Guide de l'utilisateur Page 54