HP NetServer LP 2000r Guide de l'utilisateur télécharger pdf (Page 44)

Chapter 5 Installing Additional Boards

Integrated

RA Board

Connector

Figure 5-2. Integrated RA Board Location

Installing an Accessory Board

Use this procedure to install the accessory board.

NOTE For information about a specific PCI board type, refer to the

Readme file, Tested Products List, or Configuration Advisor on

your HP Netserver Navigator CD-ROM.

1. Log off all users and, if necessary, back up files.

For detailed instructions, see "Powering Down the HP Netserver," in

Chapter 1, "Controls, Ports and Indicators."

2. Press the power switch on the HP Netserver control panel to turn off power

when prompted by the operating system.

3. Pull out the anti-tip foot at the bottom of the rack. Then slowly slide the

HP Netserver chassis out from the rack as far as it can be extended.

It is not necessary to remove the HP Netserver from the rack to install an

accessory board.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 135 136

Pas de commentaire

HP NetServer LP 2000r Guide de l'utilisateur Page 44