HP NetServer LXr 8500 Guide de l'utilisateur télécharger pdf (Page 36)

Appendix B Warranty, Software License and Support

Off board from this slot.

9. If the Slot Status for the desired PCI slot changes to Powered Off, go to

next section, "Removing a Hot Plug Board", to physically remove the PCI

board from the PCI slot (slot P5).

Removing a Hot Plug Board

Use this topic to physically remove a PCI Hot Plug Board from its PCI slot.

1. At the front of the HP NetServer, remove the front bezel from the

NetServer (refer to your Installation Guide).

2. Extend the HP NetServer chassis safely from the rack (refer to your

Installation Guide).

3. Remove the PCI Access Panel (refer to your Installation Guide).

CAUTION Do Not Drop Screws or Other Metal Objects into the HP

NetServer.

4. Verify power to the desired PCI slot is turned off, by checking the power

LED associated with the desired PCI slot. See Figure 24 and Table 7.

The green Power LED must be OFF, before attempting to open the PCI

hold-down latch.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 46 47

Pas de commentaire

HP NetServer LXr 8500 Guide de l'utilisateur Page 36