HP Server rp8400 Guide d'installation télécharger pdf (Page 36)

Chapter 3

Unpacking

Rack Mount System Installation

• Installing the ballast kit (J1479A)

• Installing the barrel nuts on the front and rear columns

• Installing the slides

Step 2. Follow the instructions on the outside of the server packaging to remove the banding and carton top

from the server pallet.

Step 3. Insert the lifter forks between the cushions.

Figure 3-5Pallet Cushion Layout without Server on Pallet

Step 4. Carefully roll the lift forward until it is fully positioned against the side of the server.

Position the Lifter Forks at These Insertion Points

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 93 94

Pas de commentaire

HP Server rp8400 Guide d'installation Page 36