Hp Insight Management-Software Manuel d'utilisateur télécharger pdf (Page 66)

remove server-port-map

The –remove server-port-map command removes a server port network mapping.

NOTE: The –remove server-port-map command cannot be used if the domain setting

vlantagcontrol is set to tunnel. This restriction is lifted for VC domain groups running VC

3.30 and later firmware mode.

Syntax

-remove server-port-map –profilename <ProfileName>

-portnumber <portnumber>

[-network <Network Name>]

Parameters

Table 26 Parameter descriptions for –remove iscsi-boot-param

OptionalRequiredDescriptionParameter

xSpecifies the name of the

profile from which the server

-profilename

port mapping is to be

removed.

xSpecifies the port number of

the server port mapping

targeted for removal.

-portnumber

xSpecifies the name of an

Ethernet network on which

the mapping exists.

-network

Output

The function returns the result of the remove operation or a jobid if –nb is specified.

Examples

• Remove a server port network mapping that has the name Rednetwork:

vcemcli -remove server-port-map –profilename MyProfile –portnumber

1 –network RedNetwork

• Remove all the server port network mappings from an Ethernet connection:

vcemcli -remove server-port-map –profilename MyProfile –portnumber

Minimum required role-based security

VCEM Group Operator

Remarks

You can obtain the job status for the jobid by executing the VCEMCLI with the –show job

command and providing the associated job ID. For more information, see “show job” (page 74).

66 Using VCEM commands

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 112 113

Pas de commentaire

Hp Insight Management-Software Manuel d'utilisateur Page 66