HP SN6000 Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 162
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
HP SAN Connection Manager User Guide 15
13. When you restart your computer, the system may report finding new hardware. If so, respond to these
messages by clicking Cancel.
T
Figure 4 Installation wizard: Enable VCEM Server Enclosure Discovery
Repeat this procedure to install the software on additional Windows servers.
Linux installation: initial
Follow these steps to install the required software on servers running Linux.
NOTE: To configure servers using other operating systems or non-QLogic HBAs, see “Configuring SAN
Connection Manager for HP-UX and Emulex HBAs, page 17.
To install the components required by SAN Connection Manager on Linux:
1. Insert the installation CD into the CD-ROM drive of the server.
The installation CD should mount automatically in one of the following locations:
/media/cdrom/
/mnt/cdrom/
/media/cdrecorder/
If the installation CD is not mounted automatically, issue the following commands to mount the CD:
# mkdir -p /mnt/cdrom
# mount /dev/cdrom /mnt/cdrom
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 161 162

Commentaires sur ces manuels

Pas de commentaire