Hp Hitachi Dynamic Link Manager Software Manuel d'utilisateur Page 319

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 652
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 318
4. HDLM Operation
297
1. Set up the storage system and switch so that Solaris recognizes the LU.
2. Check the LU newly recognized by the node.
You can check the LU by using the
format command. Figure 4-2: Example of
executing the format command shows an example of executing the
format
command. The shaded portion represents the LU newly recognized by the node.
Figure 4-2: Example of executing the format command
3. If setup is performed for Quorum devices and disk device groups, on an LU newly
recognized by the node, release these settings.
When you unregister the SDS or SVM diskset, the diskset data will be deleted so
first back up any necessary data. For details on how to remove settings for
Quorum devices and VxVM disk groups, see (2) Remove Sun Cluster Settings of
3.17.2 Preparations for HDLM Uninstallation. For details on how to remove
SDS or SVM disksets, see (5) Remove SDS Settings or (6) Remove SVM Settings
of 3.17.2 Preparations for HDLM Uninstallation.
4. Make sure that the key used for disk reservation has been registered for the LU
newly recognized by the node.
Vue de la page 318
1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 651 652

Commentaires sur ces manuels

Pas de commentaire