Hp StorageWorks 500 Modular Smart Array Manuel d'utilisateur télécharger pdf (Page 49)

Hardware Options Installation

HP StorageWorks Modular Smart Array 500 System User Guide 3-5

4. Be sure that the drive LEDs illuminate one at a time and then turn off together to

indicate that the system has recognized the new drive.

In fault-tolerant configurations, allow the replacement drive to be reconstructed

automatically with data from the other drives. While reconstruction is in

progress, the online LED flashes.

Universal Hot-Plug Tape Drive Option

The MSA500 system supports the Universal Hot-Plug Tape drive (AIT and DDS-4

types) for data storage and backup. The option supports Microsoft and Novell

operating systems in various configurations.

For specific Universal Hot-Plug Tape drive configurations, refer to the HP website

www.hp.com/products/sharedstorage

When installed, the hot-plug tape drive fills two storage system hard drive bays. For

complete information, refer to the documentation that ships with the Universal

Hot-Plug Tape drive.

To install a tape drive:

1. Remove two adjacent hard drive blanks. Refer to “Removing Hard Drive Blanks”

in this chapter.

CAUTION: Installation of the tape drive height converter is permanent.

Attempting to remove the converter after installation voids the tape drive

warranty.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 156 157

Pas de commentaire

Hp StorageWorks 500 Modular Smart Array Manuel d'utilisateur Page 49