HP EliteDesk 800 G3 Small Form Factor PC (ENERGY STAR) Manuel d'utilisateur Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 59
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
c. If you are removing a PCI Express x16 card, pull the retention arm on the back of the expansion
socket away from the card (1) and carefully rock the card back and forth until the connectors pull
free from the socket. Lift the card straight up (2) then away from the inside of the chassis (3) to
remove it. Be sure not to scrape the card against other components.
10. Store the removed card in anti-static packaging.
11. If you are not installing a new expansion card, install an expansion slot cover to close the open slot.
IMPORTANT: After removing an expansion card, you must replace it with a new card or expansion slot
cover for proper cooling of internal components during operation.
12. To install a new expansion card, hold the card just above the expansion socket on the system board then
move the card toward the rear of the chassis (1) so that the bottom of the bracket on the card slides into
the small slot on the chassis. Press the card straight down into the expansion socket on the system
board (2).
NOTE: When installing an expansion card, press rmly on the card so that the whole connector is
seated properly in the expansion card socket.
Removing or installing an expansion card 19
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 58 59

Commentaires sur ces manuels

Pas de commentaire