HP EliteDesk 800 G3 Small Form Factor PC (ENERGY STAR) Manuel d'utilisateur télécharger pdf (Page 27)

Drive positions

1 3.5-inch secondary hard drive bay

2 3.5-inch primary hard drive bay

3 2.5-inch hard drive bay

4 9.5 mm slim optical drive bay

NOTE: The drive conguration on your computer may be dierent than the drive

conguration shown above.

Removing and installing drives

When installing drives, follow these guidelines:

● The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on

the system board labeled SATA0.

● Connect secondary hard drives and optical drives to one of the light blue SATA connectors on the system

board (labeled SATA1, and SATA3).

IMPORTANT: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn o the computer, and

unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid

touching the connector. For more information about preventing electrostatic damage, refer to Electrostatic

discharge on page 49.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic elds such as

monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the

package “Fragile: Handle With Care.”

Drive positions 21

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 58 59

Pas de commentaire

HP EliteDesk 800 G3 Small Form Factor PC (ENERGY STAR) Manuel d'utilisateur Page 27