HP D2600 Manuel d'utilisateur télécharger pdf (Page 51)

8 Troubleshooting

If the enclosure does not initialize

IMPORTANT:

After a power failure, the system automatically returns to the last-powered state (On or Off) when

A/C power is restored.

1. Ensure that the power on/standby button was pressed firmly and held for approximately three

seconds.

2. Verify that the power on/standby button LED is green.

3. Verify that the power source is working:

a. Verify that the power supplies are working by viewing the power supply LEDs. If necessary,

remove and reinstall the power supplies to verify that they are seated properly.

b. Remove and inspect AC power cords from both power supplies and reconnect them.

Diagnostic steps

Is the enclosure front fault LED amber?

ActionsPossible ReasonsAnswer

No action required.System functioning properly.No

• Be sure that the Front Status and

UID module is undamaged and

is fully seated.

• Check rear fault LEDs to isolate

failed component.

• Contact an authorized service

provider for assistance.

• Front Status and UID module

might not be inserted properly,

might have a damaged connect-

or, or might have failed.

• Possible error condition exists.

Yes

D2600/D2700 Disk Enclosure User Guide 51

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 75 76

Pas de commentaire

HP D2600 Manuel d'utilisateur Page 51