HP 3700 series Manuel d'utilisateur Page 131

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 250
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 130
NOTE
If the old transfer unit was not at end-of-life when it was replaced (for example, if it was
damaged), or if you want to continue printing past the end-of-life message, the transfer unit
count must be reset using the printer control panel. Please note that the end-of-life message
is provided as a customer service, and printing past it is likely to result in print quality
degradation in the near future. Once the transfer kit count has been reset after an end-of-life
message, feedback on the kit's remaining life will be incorrect until the kit is replaced and the
count is reset again.
To reset the transfer unit count
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight RESETS.
5. Press
to select RESETS.
6. Press
to highlight RESET SUPPLIES.
7. Press
to select RESET SUPPLIES.
8. Press
to highlight NEW TRANSFER KIT.
9. Press
to select NEW TRANSFER KIT.
10. Press
to highlight YES.
11. Press
to select YES.
The transfer unit count is reset and the printer is ready to use.
Replacing the fuser and pickup roller
Replace the fuser and pickup roller when the printer control panel displays the message
REPLACE FUSER KIT. The image fuser kit contains a replacement fuser and a Tray 2
pickup roller for this printer. After replacing the fuser, you must also replace the pickup roller.
Instructions for replacing the pickup roller follow the instructions for replacing the fuser.
To replace the fuser
1. Turn the printer off.
ENWW Replacing supplies and parts 119
Vue de la page 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 249 250

Commentaires sur ces manuels

Pas de commentaire