Hp 3300mfp Manuel d'utilisateur Page 202

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 259
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 201
200 16 Troubleshooting network problems EN
TCP/IP protocol information
Provides the current status and parameter values for the TCP/IP network protocols.
Unicast Packets
Received
Number of frames specifically addressed to this print server. This does not
include broadcasts or multicasts.
Bad Packets Received Total number of frames (packets) received with errors by the print server.
Framing Errors
Received
Maximum of CRC (Cyclic Redundancy Check) errors and framing errors.
CRC errors are frames received with CRC errors. Framing errors are
frames received with alignment errors. A large number of framing errors
could indicate a cabling problem with your network.
Total Packets
Transmitted
Total number of frames (packets) transmitted without error.
Unsendable Packets Total number of frames (packets) not successfully transmitted because of
errors.
Transmit Collisions Number of frames not transmitted because of repeated collisions.
Transmit Late
Collisions
Total number of frames not transmitted because a late collision occurred. A
large number may indicate a cabling problem on the network.
Message Description
Status Current TCP status:
Ready the print server is awaiting data over TCP/IP.
Disabled TCP/IP was manually disabled.
Initializing the print server is searching for the BOOTP server, or
trying to get the configuration file through TFTP. An additional status
message may also be displayed.
An error code and message are displayed if the print server is not ready.
Host Name The host name configured on the print server. It may be truncated.
Not Specified no host name was specified in a BOOTP response
or TFTP configuration file.
NPIxxxxxx the default name is NPIxxxxxx, where xxxxxx represents
the last six digits of the LAN hardware (MAC) address.
IP Address The Internet Protocol (IP) address assigned to the print server. This is a
required entry for its operation on a TCP/IP network. During initialization, a
temporary value 0.0.0.0 is displayed. After two minutes, a default IP
address 192.0.0.192 is assigned, which may not be a valid IP address for
your network.
Not Specified an IP address is not assigned or the value is zero.
Message Description
Vue de la page 201
1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 258 259

Commentaires sur ces manuels

Pas de commentaire