Hp Netserver E Server series Manuel d'utilisateur télécharger pdf (Page 25)

Chapter 3 Installing Mass Storage Devices

Slots for Tabs

Captive

Screws (3)

First, insert screws through

round holes in back

(one each side).

Tabs(2)

Figure 3-2. Adding a Hard Disk Drive

CAUTION All mounting screws used to thread into the hard disk drive

must be #6-32 and not exceed ¼-inch in length. Longer

screws may cause internal damage to the mass storage device.

Damage caused by incorrect mounting screws is not covered

by the HP warranty.

10. Align the drive's screw holes with the holes in the hard disk drive cage and

install the screws to secure the drive to the hard disk drive cage.

a. Attach one of the screws through the round screw hole at the rear of the

cage.

b. Attach another screw through the round hole at the front of the cage on

the same side.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 105 106

Pas de commentaire

Hp Netserver E Server series Manuel d'utilisateur Page 25