Hp ProLiant ML310 G2 Server Manuel d'utilisateur télécharger pdf (Page 49)

Hardware Options Installation 49

Hot-Plug SATA and SAS Hard Drives

Hot-plug SATA and hot-plug SAS hard drives can be used interchangeably when

a SAS controller is installed. The SATA controller is embedded, but before

installing a hot-plug SAS hard drive, install the SAS controller ("SAS

Controller" on page 50

To remove the component:

CAUTION: To prevent improper cooling and thermal damage,

do not operate the server unless all bays are populated with either a

component or a blank.

1. Determine the status of the hard drive from the hot-plug hard drive LEDs

("Hot-Plug SCSI Hard Drive LED Combinations" on page 18

, "Hot-Plug

SCSI Hard Drive LEDs" on page 17

2. Back up all server data on the hard drive.

3. Disconnect the cables from the hot-plug SATA or SAS drive cage.

4. Remove the hard drive.

To replace the component:

1. Remove the existing hard drive blank or hard drive from the drive bay.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 123 124

Pas de commentaire

Hp ProLiant ML310 G2 Server Manuel d'utilisateur Page 49