Hp ProLiant ML310 G2 Server Manuel d'utilisateur Page 71
- Page / 124
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Server Software and Configuration Utilities 71
USB Support
HP provides both standard USB support and legacy USB support. Standard
support is provided by the operating system through the appropriate USB device
drivers. HP provides support for USB devices before the operating system
loading through legacy USB support, which is enabled by default in the system
ROM. HP hardware supports USB version 1.1 or 2.0, depending on the version
of the hardware.
Legacy USB support provides USB functionality in environments where USB
support is normally not available. Specifically, HP provides legacy USB
functionality for:
•
•
•
•
•
POST
RBSU
Diagnostics
DOS
Operating environments which do not provide native USB support
For more information on ProLiant USB support, refer to the HP website
(http://h18004.www1.hp.com/products/servers/platforms/usb-support.html
).
Internal USB Functionality
An internal USB connector is available for use with USB drive keys only. The
internal connector shares the same bus with the front external USB connector,
and connecting a device to both the front internal and front external USB
connectors is not supported. This solution provides for use of a permanent boot
drive from a USB drive key installed in the front internal connector, avoiding
issues of clearance on the front of the rack and physical access to secure data.
For additional security, you can individually disable the front, rear, and internal
USB connectors through RBSU. Disabling the rear USB connectors in RBSU
disables both rear USB ports.
- User Guide 1
- Audience Assumptions 2
- Contents 3
- Front Panel Components 7
- Front Panel LEDs and Buttons 8
- Rear Panel Components 9
- Rear Panel LEDs and Buttons 10
- System Board Components 11
- System Board LEDs 13
- SCSI IDs 16
- Identifying Fans 19
- Server Operations 21
- Unlocking the Tower Bezel 22
- Removing the Access Panel 22
- Server Operations 23 23
- Server Setup 25
- Rack Planning Resources 26
- Optimum Environment 27
- Temperature Requirements 28
- Power Requirements 29
- Rack Warnings and Cautions 30
- Server Setup 31 31
- Installing Hardware Options 33
- Setting up a Tower Server 33
- Server Setup 35 35
- Registering the Server 36
- Introduction 37
- Processor and Heatsink 38
- Memory Options 41
- Installing DIMMs 42
- Hard Drive Options 43
- Non-Hot-Plug SATA Hard Drive 44
- 6. Remove the hard drive 45
- To replace the component: 45
- Non-Hot-Plug SCSI Hard Drive 46
- SAS Controller 50
- Removing the CD-ROM Drive 51
- DVD-ROM Drive 52
- Optional Diskette Drive 53
- Expansion Boards 54
- Installing Expansion Boards 55
- Server Cabling 57
- Non-Hot-Plug SCSI Cabling 58
- Hot-Plug SATA Cabling 59
- Non-Hot-Plug SATA Cabling 59
- SAS Cabling 60
- Configuration Tools 61
- HP ROM-Based Setup Utility 63
- Array Configuration Utility 65
- Management Tools 67
- Automatic Server Recovery 68
- ROMPaq Utility 68
- Erase Utility 69
- Management Agents 70
- HP Systems Insight Manager 70
- Diagnostic Tools 72
- Keeping the System Current 73
- Drivers 74
- Resource Paqs 74
- ProLiant Support Packs 75
- Care Pack 75
- Battery Replacement 77
- 5. Remove the battery 78
- Troubleshooting 79
- Important Safety Information 80
- Warnings and Cautions 81
- Troubleshooting 83 83
- Symptom Information 84
- Service Notifications 85
- Loose Connections 85
- Diagnostic Steps 85
- Start Diagnosis Flowchart 86
- Troubleshooting 87 87
- General Diagnosis Flowchart 88
- Troubleshooting 89 89
- Power-On Problems Flowchart 90
- Troubleshooting 91 91
- POST Problems Flowchart 93
- OS Boot Problems Flowchart 95
- Troubleshooting 97 97
- Troubleshooting 99 99
- ROMPaq Disaster Recovery 101
- Manual Recovery 101
- Other Information Resources 102
- FCC Rating Label 104
- Class A Equipment 104
- Class B Equipment 105
- Mouse Compliance Statement 106
- Modifications 106
- Japanese Notice 108
- BSMI Notice 108
- Laser Compliance 108
- Battery Replacement Notice 109
- Electrostatic Discharge 111
- Discharge 112
- Server Specifications 113
- Technical Support 115
- Before You Contact HP 116
- Acronyms and Abbreviations 117
Produits connexes et manuels pour Matériel informatique Hp ProLiant ML310 G2 Server
(147 pages)
(93 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels