Hp ProLiant ML350e Gen8 Server Manuel d'utilisateur télécharger pdf (Page 33)

Operations 33

Remove a fan

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless

all bays are populated with either a component or a blank.

To remove the component:

1. Do one of the following:

o For tower models, open and remove the bezel ("Remove the tower bezel" on page 22).

o For rack models, if installed, remove the security bezel (on page 24).

2. Power down the server (on page 22).

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Do one of the following:

o For tower models, place the server on a flat, level surface with the access panel facing up.

o For rack models, extend the server from the rack (on page 27).

5. Remove the access panel (on page 25).

6. If installed, remove the PCI air baffle (on page 28).

7. Remove any installed full-length PCI expansion cards ("Remove a full-length expansion board" on page

37).

8. Remove the system air baffle (on page 30).

9. Remove the fan cage (on page 31).

10. Remove the fan.

Remove the FBWC capacitor pack

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 146 147

Pas de commentaire

Hp ProLiant ML350e Gen8 Server Manuel d'utilisateur Page 33