HP 132A Manuel d'utilisateur télécharger pdf (Page 258)

Chapter 4 Command Reference

[:SENSe] Subsystem

4-92 Programming Guide

[:SENSe]:PHASe:ARM[:STARt]:SOURce IMMediate | EXTernal

Sets or queries the start arm for Phase measurements.

A sequence of ASCII-encoded bytes: IMM or EXT

*RST: IMMediate

Gate & ExtArm

[:SENSe]:ROSCillator Subtree

This subtree controls the Reference Oscillator .

[:SENSe]:ROSCillator:EXTernal:CHECk ON | OFF | ONCE

Sets or queries the enable for “checking” the validity and presence of the external

reference.

When CHECk is ON and external has been explicitly selected

([:SENS]:ROSC:SOUR is EXT and [:SENS]:ROSC:SOUR:AUTO is OFF), the

Counter checks the external reference signal to ensure that the frequency is 1, 5, or

10 MHz and that the reference is present at measurement completion. Note that

the HP 53132A only accepts 10 MHz. When CHECk is OFF, the external

reference signal is not checked at all.

CHECk ONCE is an event which invokes the external reference check at the time

the command is executed. ONCE is only permitted if [:SENS]:ROSC:SOUR is

EXT; otherwise, error -221 is generated.

If the CHECk ONCE does not detect a valid timebase, error +2009 is generated.

After the check is completed, this command’s parameter is set to OFF.

Query Response

Comments

Front-Panel

Keys

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 329 330

Pas de commentaire

HP 132A Manuel d'utilisateur Page 258