HP 24S Guide de l'utilisateur télécharger pdf (Page 33)

Connecting a Modem and Terminal

1. Use a full-duplex, asynchronous (character-mode) modem only. The following

modems have been tested at their rated speeds:

– HP 37212B Support Link

– HP 35031A Support Link II

– HP 50759A Support Link

– Hayes 1200 Smartmodem

– Racal Vadic Maxell 2400VP (Hayes 2400 compatible)

– Black Box V.32 9600 Baud.

2. Configure the modem as described in appendix C, “Modem Configuration”.

3. Connect the modem to the console port using an RS-232-C modem cable. (For

pin-outs and recommended cables see appendix A, “Cables and Connectors”.)

4. At the remote site, connect the terminal (or PC emulating a terminal) to the

remote modem. Make sure the terminal and modems are functioning properly,

then establish the link between the terminal’s modem and the hub’s modem

according to the modem instructions.

5. Press RETURN several times for the prompt =>. The baud rate for

communication between the hub and the terminal is set automatically when you

press RETURN.

Installation 2-15

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 101 102

Pas de commentaire

HP 24S Guide de l'utilisateur Page 33