HP 24S Guide de l'utilisateur télécharger pdf (Page 41)

IPconfig (HP 28688B and HP 28699A Only)

To set IP configuration parameters on the hub. Use this command if you wish the

hub to be accessible using IP (the Internet Protocol). If either of the following is true, you

must set the IP configuration parameters on the hub:

The hub will be managed remotely with a network management product, such as

HP OpenView Hub Manager or HP OpenView Interconnect Manager, over an IP

network (a network operating system that uses IP communications).

The network cable segments attached to the hub will be tested using the IP “Ping”

test.

Note

Novell NetWare uses the IPX protocol. If you are using the hub on a

Novell NetWare network, no configuration of the hub is required for it to

communicate with a network management station that is also using the

IPX protocol. IPX is automatically enabled on the hub. The hub

determines its IPX address automatically from information received from

a router or file server that is running IPX on the network, and from its

own station address (also sometimes called the MAC address, physical

address, or Ethernet address).

See appendix D, “Network Addressing” for more information.

At the console interface prompt, enter IP and you will be prompted to enter values for the

parameters listed on the next page.

Operation 3-5

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 101 102

Pas de commentaire

HP 24S Guide de l'utilisateur Page 41