HP E5000 Guide de l'utilisateur Page 114

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 199
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 113
Replacing the enclosure rails
1. Align the replacement rail, and then attach it by sliding the rail toward the front of the enclosure
(Figure 125 (page 114)).
Figure 125 Installing the enclosure rails
2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive
drawer partially back into the system enclosure so that approximately two inches of the drawer
is still out of the enclosure (Figure 126 (page 114)).
CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect
the power coil assembly to prevent damaging the power coil assembly.
Figure 126 Partially installing the drive drawer
3. Pull the cable slightly out of the coil power plug and connect it to the midplane board
(Figure 127 (page 115)).
114 Removing and replacing hardware components
Vue de la page 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 198 199

Commentaires sur ces manuels

Pas de commentaire