HP E5000 Guide de l'utilisateur télécharger pdf (Page 94)

3. Remove all eight screws from the front bezel (1, Figure 87 (page 94)), and then lift the front

bezel up and out to remove the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Figure 87 Removing the front bezel

Replacing the front bezel

1. Install the replacement front bezel with the handle at a 90 degree angle making sure the

bottom pins are aligned with the bottom holes (1, Figure 88 (page 94)), and replace the

screws into the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Figure 88 Replacing the front bezel

2. Push the drive drawer back into the system enclosure.

3. Power on the system by pressing the power button ON.

4. Verify that the replacement component is working properly by checking the associated LED

status.

5. Confirm that the system has resumed normal operations.

94 Removing and replacing hardware components

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 198 199

Pas de commentaire

HP E5000 Guide de l'utilisateur Page 94