HP E5000 Guide de l'utilisateur télécharger pdf (Page 162)

Restore Factory Defaults (Fd)

You might be replacing an EM or reconfiguring a messaging system. The action resets the EMU

address to a link local IP address (not the factory default).

To restore factory defaults:

1. Enter the menu mode using the “Activate Button Menu” (page 161).

2. Press the UP button until the display changes from “_ _“ to “Fd”.

3. Press and hold the UP button for three seconds.

The EM blinks (or flashes) “Fd” three times to acknowledge the selection.

4. Release the UP button.

The system stops flashing the pattern, internally restores all configurations to factory defaults,

and reboots the EM.

Recover Lost Password (Fp)

You changed the Administrator password from the default password set by the factory, and then

lost or forgot the new password.

To recover a lost password:

1. Enter the menu mode using the “Activate Button Menu” (page 161).

2. Press the UP button until the display changes from “_ _“ to “Fp”.

3. Press and hold the UP button for three seconds.

The EM blinks (or flashes) “Fp” to acknowledge the selection.

4. Release the UP button.

The system stops flashing “Fp”. The system restores the Administrator password from hardware

and logs the event in the syslog. The system displays the Enclosure ID to indicate that the

operation is complete.

Set DHCP IP Address (dH)

Reconfigure the messaging system for a different network where IP address assignment is handled

dynamically.

To set a DHCP IP address:

1. Enter the menu mode using the “Activate Button Menu” (page 161).

2. Press the UP button until the display changes from “_ _“ to “dH”.

3. Press and hold the UP button for three seconds.

The EM flashes “dH” to acknowledge the selection.

4. Release the UP button.

The system sets the EM to DHCP and exits the menu mode. This event is also logged in the

EM syslog and takes effect immediately. The system displays the Enclosure ID to indicate that

the operation is complete.

Set Link Local IP Address (LL)

Reconfigure the messaging system for a network where IP address assignment is static.

To set a static IP address:

1. Enter the menu mode using the “Activate Button Menu” (page 161).

2. Press the UP button until the display changes from “_ _“ to “LL”.

3. Press and hold the UP button for three seconds.

The EM flashes “LL” to acknowledge the selection.

162 Managing the EMU

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 198 199

Commentaires sur ces manuels

Pas de commentaire

HP E5000 Guide de l'utilisateur Page 162

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP E5000