HP Modular Cooling System Guide de l'utilisateur télécharger pdf (Page 34)

Web interface 34

NOTE: When DHCP is enabled, the IP Address, Network Mask, and Default Gateway fields

are not available.

1. Select to enable or disable NTP from the Network Time Protocol (NTP) radio buttons.

2. If you enable NTP:

a. Enter the IP address of the primary NTP server in the Primary NTP Server field.

b. Enter the IP address of the secondary NTP server in the Secondary NTP Server field.

NOTE: If NTP is not enabled, selecting a time zone from the NTP GMT Offset dropdown box

changes the system clock by the hours offset.

c. Select the time zone from the NTP GMT Offset dropdown box.

d. Enter the number of hours that should pass between each date and time update in the NTP

Update Frequency field.

e. Proceed to step 4.

3. If you do not enable NTP:

a. Enter the date in the Date field on the General menu (on page 32).

b. Enter the time in the Time field on the General menu (on page 32).

c. Enter the date for DST to begin in the DST Begin field.

d. Enter the date for DST to end in the DST End field.

e. Proceed to step 4.

4. Do one of the following:

o Click Save Settings to save the information.

o Click Cancel to undo the changes.

Click Ping to test the network connectivity to another device IP address.

Management menu

Click Management in the left navigation frame to access the Management screen. This screen enables the

Admin to configure network management settings for the management module.

The Management screen contains the following:

• System Information tab

• Trap Receivers tab (on page 35)

• SNMP Managers tab

• Remote Access tab

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Pas de commentaire

HP Modular Cooling System Guide de l'utilisateur Page 34