HP VMA-series Memory Arrays Manuel d'utilisateur Page 138
- Page / 278
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
138 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
Enable or disable the specified alarm. There are three alarms that can be enabled or
disabled:
cpu_util_indiv (CPU utilization too high), paging (paging activity
too high), and
fs_mnt (filesystem low on free space).
stats alarm <alarm ID> rising error-threshold <threshold>
stats alarm <alarm ID> rising clear-threshold <threshold>
stats alarm <alarm ID> falling error-threshold <threshold>
stats alarm <alarm ID> falling clear-threshold <threshold>
Change the thresholds which will initiate or terminate (clear) the specified alarm.
New alarms cannot be added through this interface, only existing ones can be
changed.
The units for the
cpu_util_indiv alarm are hundredths of a point of the one-
minute load average. For example, setting it to 100 will cause an alarm if the one-
minute load average is ever over 1.0 when it is sampled.
The units for the
paging alarm are number of pages read from or written to the
swap partition. The alarm is on the amount of paging activity that has occurred over
the past 20 seconds.
stats alarm <alarm ID> rate-limit window short <duration>
stats alarm <alarm ID> rate-limit window medium <duration>
stats alarm <alarm ID> rate-limit window long <duration>
Configure the alarm event rate-limit duration windows for the three types of
durations for alarms.
stats alarm <alarm ID> rate-limit count short <count>
stats alarm <alarm ID> rate-limit count medium <count>
stats alarm <alarm ID> rate-limit count long <count>
Configure the alarm event rate-limit maximum counts for the three types of counts
for alarms.
stats alarm <alarm ID> rate-limit reset
Reset the rate-limit counters and time for the specified alarm.
show stats alarm [<alarm ID>]
Display status of all alarms or the specified alarm: whether or not it is in an error
state.
- HP VMA SAN Gateway 1
- Installation and User Guide 1
- LEGAL NOTICES 2
- Mountain View, CA 94043USA 3
- Table of Contents 5
- List of Figures 9
- Document Conventions 11
- Security & Compliance 12
- Compliance Information 12
- Notice Description 13
- Contacting HP 14
- Before you contact HP 14
- HP contact information 14
- Subscription Service 14
- Reference Documents 15
- Documentation feedback 15
- HP VMA SAN Gateway Overview 17
- Deployment Overview 23
- Phase 5: vSHARE Configuration 26
- Front View 28
- Rear View 29
- Connecting Power 31
- Connecting Network Interfaces 32
- Table 2.2 Modem Settings 34
- Cluster Network Configuration 37
- Configuring Network Settings 38
- Cluster Management VIP 54
- Monitoring the Cluster 54
- Saving Configurations 57
- Show Configuration Files 60
- Show Configuration 61
- User Management 63
- Software Upgrades 64
- Configuring vSHARE 65
- Scale-out Clustering 66
- Provisioning API 66
- Storage Management 66
- [block] [force][name] 70
- 2. Enter Config mode 71
- Configuring Target Ports 73
- Configuring Initiator Groups 74
- Creating LUNs 76
- Table 4.3 lun create Command 78
- Table 4.4 show luns Command 79
- Exporting LUNs 80
- Table 4.5 lun export Command 81
- Port BPort A 83
- Shared Partition 83
- Configuring Interface Bonding 85
- HP VMA memory array 86
- Gateway 2 86
- Gateway 1 86
- Operating vSHARE 89
- Table 5.1 Show Media Options 92
- Managing Containers 102
- Managing Initiator Groups 102
- Managing LUNs 102
- Managing Targets 104
- Monitoring LUN Status 104
- Figure 5.1 LUN Status Page 105
- Managing Initiators 109
- Fibre Channel Target Ports 111
- Command Line Interface 113
- Getting Help 114
- Tab Completion of Commands 116
- Command Modes 117
- CLI Command Descriptions 120
- Key to Command Parameters 120
- NTP, Clock, and Time Zones 129
- Event Notification 131
- For example: 133
- Diagnostic Tools 135
- Statistics 137
- Configuration File Management 140
- Image Management 143
- Enable and Config Modes 144
- Web Proxy Settings 145
- Xinetd Server Settings 145
- Debug Dumps 146
- Network Interface Commands 148
- Network Bond Commands 150
- VLAN Commands 151
- Name Resolution Commands 152
- Routing Commands 152
- Additional CLI Commands 152
- ARP Configuration 152
- RADIUS Configuration 154
- TACACS+ Configuration 155
- SSH Configuration 157
- CLI Options 159
- SNMP Configuration 162
- Media Management Commands 167
- Media Initialization 167
- Media Enable 167
- Show Media 168
- Containers 170
- Initiator Groups 171
- Quick Reference to Commands 173
- S: Standard Mode 174
- E: Enable Mode 174
- C: Config Mode 174
- VMA Web Interface Reference 177
- Category Pages 179
- Table B.2 Supported Browsers 181
- Printing Pages 182
- Login and Logout 183
- Logout Page 184
- Cluster Management 184
- Cluster Status Page 184
- Figure B.4 Status Page 185
- Figure B.5 Board Status Page 186
- Gateways Page 188
- Figure B.9 Alerts Page 190
- Logs Page 191
- Versions Page 191
- Administration Pages 192
- Cluster Administration Page 193
- Network Page 194
- DNS Settings Page 195
- NTP Settings Page 196
- Web Administration Page 196
- Feature Licenses Page 198
- Users Page 199
- Alert Recipients Page 200
- Call Home 202
- Tools Pages 202
- Tools: Upgrade 203
- Tools: Diagnostics 204
- Help Pages 204
- Help: Documentation 204
- Help: About 204
- Help: License 205
- Help: Acknowledgements 205
- LUN Status 205
- LUN Management 206
- Initiator Management 209
- Target Management 210
- VMA Utilities 213
- VMA Utilities Reference 214
- <partition_name> 226
- # vspeedtest 227
- Version G5.1.x 239
- Trap Information Table 243
- Configuring and Testing Traps 248
- Spare VIMMs 249
- Failed VIMMs 249
- PSU States 249
- Performance Stats 253
- New Trap MIB Objects 255
- vmemModel 258
- Regulatory Information 268
- Regulatory Model Number 268
- Installation Conditions 268
- Network Connected Equipment 268
- Lithium Battery Caution 269
- Cabinet Safety Precautions 269
- European Union RFI Statement 270
- Korea RFI Statement 271
- Canada RFI Statement 271
- Australia C-Tick Label 271
- Taiwan BSMI Statement 271
Commentaires sur ces manuels
Produits connexes et manuels pour Mise en réseau HP VMA-series Memory Arrays
(44 pages)
Mise en réseau HP MT40 Guide de dépannage
(31 pages)
(31 pages)
Mise en réseau HP MSM7XX Manuel d'utilisateur
(206 pages)
(206 pages)
Mise en réseau HP 11i Manuel d'utilisateur
(54 pages)
(54 pages)
Mise en réseau HP J3188A Manuel d'utilisateur
(100 pages)
(100 pages)
Mise en réseau HP 620n Guide de l'utilisateur
(264 pages)
(264 pages)
Mise en réseau HP F100 Manuel d'utilisateur
(46 pages)
(46 pages)
Mise en réseau HP 640n Guide de l'utilisateur
(228 pages)
(228 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.026 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
5 Lessons You Can Learn From Pornstar UK pornstar uk
7 Simple Secrets To Totally Moving Your Xxx Of Pornstar xxx of pornstar