HP NetServer LH 3000 Guide d'installation télécharger pdf (Page 15)

Chapter 2 Installation

4. Using the two circular access holes in the chassis shown in Figure 2-3,

insert and tighten two screws supplied with the upgrade kit.

◊ HP NetServer LH 3000 and LH 6000 access holes are on the side of the

chassis.

◊ HP NetServer LH 3000r and LH 6000r access holes are on the top of

the chassis.

Figure 2-3. Insert and Tighten Two Screws (1),

and Then Insert and Tighten Six Screws (2)

5. Insert six screws into the front of the hot-swap mass storage cage, as

shown in Figure 2-3, and tighten them.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

HP NetServer LH 3000 Guide d'installation Page 15