HP NetServer LH 3000 Guide d'installation télécharger pdf (Page 38)

Chapter 3 Configure Mass Storage

11. The Embedded LAN and SCSI Settings submenu is displayed. If

HP NetRAID/LVD SCSI is not already highlighted, use the up and down

arrows to highlight it.

Read the values in the brackets to determine whether LVD SCSI is

enabled.

◊ Enable LVD SCSI indicates that LVD SCSI is enabled and

HP NetRAID is disabled. This is the correct setting for non-RAID

operation of the mass storage cages connected to SCSI A and B on the

I/O baseboard.

◊ Enable HP NetRAID indicates that HP NetRAID is enabled to

provide RAID operation of the mass storage cages connected to

SCSI A and B on the I/O baseboard. This is the default value.

CAUTION If your HP NetServer was previously operating in RAID mode

(Enable HP NetRAID), changing to non-RAID mode (Enable

LVD SCSI) could cause data loss. Be sure your data is backed

up before you change to non-RAID mode.

If the value is not Enable LVD SCSI, use the +/- keys to change it to

Enable LVD SCSI. This change will take effect when the HP NetServer

restarts.

Exit Setup Utility

12. Press the F10 function key to save and exit.

13. In the Setup Confirmation dialog box, press Enter to answer "Yes" to the

question, "Save configuration changes and exit now?" The HP NetServer

will restart.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Pas de commentaire

HP NetServer LH 3000 Guide d'installation Page 38