HP NetServer LH 3000 Guide d'installation télécharger pdf (Page 20)

Chapter 2 Installation

2. Connect the SCSI cable’s 68-pin connector labeled "To I/O Board" to the

SCSI B connector on the I/O baseboard, as shown in Figure 2-6.

To attach the 68-pin connector, press on the center of the connector strain

relief and press the connector into place, as shown in Figure 2-7. Two

clicks indicates the connector is properly installed.

Figure 2-7. Attach SCSI Cable Connector

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Pas de commentaire

HP NetServer LH 3000 Guide d'installation Page 20