HP Visualize c3000 Manuel d'instructions Page 105

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 246
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 104
Chapter 5 105
Changing Your Computer Hardware Configuration
System Unit Power Supply
Closing the System Unit After Propping Up the Power Supply
Once you complete the task you set out to perform, you are ready to close
the system unit. To close the system unit follow these steps:
1. Pull slightly back on the power supply until you are able to remove
the bail from the bail lock. Using the power supply handle lower it
downward into its original operating position. See Figure 5-3.
2. Tighten both captive screws in place as seen in Figure 5-3. Use a T-15
Torx driver and 6 inch-pounds of torque to tighten the screws.
3. Replace the left side panel of the system unit as shown in the section
“Closing the Left Side Panel of the System Unit” in this chapter.
Vue de la page 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 245 246

Commentaires sur ces manuels

Pas de commentaire