HP Visualize c3000 Manuel d'instructions Page 93

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 246
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 92
Chapter 4 93
SCSI Connections
Connecting to the SCSI Ports
Connecting to the SCSI Ports
This section describes how to connect to the system SCSI ports (Ultra
Narrow Single-Ended and Ultra2 Wide Low-Voltage Differential).
System SCSI Port Connection
The system contains two SCSI connectors:
Ultra Narrow Single-Ended SCSI (NSE SCSI) connector
Ultra2 Wide Low-Voltage Differential SCSI (LVD SCSI) connector
The illustration below shows the two SCSI connectors. SCSI cables
connect to these ports with a high-density thumbscrew connector.
NOTE It is necessary to put a terminator on unused SCSI connectors on the
back panel, or the last device connected to the SCSI bus. Terminators are
shipped with the system. Be sure to use a NSE SCSI terminator for the
NSE SCSI bus and an LVD SCSI terminator for the LVD SCSI bus.
Ultra2 Wide
Low-Voltage
Differential
SCSI Connector
Ultra Narrow Single-Ended SCSI Connector
Vue de la page 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 245 246

Commentaires sur ces manuels

Pas de commentaire