HP Visualize c3000 Manuel d'instructions télécharger pdf (Page 196)

196 Chapter6

The Boot Console Interface

Displaying and Setting the Security Mode

The secure ﬂag is a variable stored in non-volatile memory.

(Non-volatile memory retains its contents even after power is turned off.)

If you reset this ﬂag to a new value, the change takes effect the next time

you reboot the computer.

When the secure ﬂag is set to on, auto boot and auto search are enabled

and cannot be stopped. The system boots from the default boot paths

regardless of user intervention.

Note that the secure command must be executed from within the Boot

Console Interface. To get into the Boot Console Interface, follow the

procedure in the section “Accessing the Boot Console Interface” in this

chapter. Once the Main Menu is present, you can type the following

command at the prompt and press Enter:

Main Menu: Enter command > configuration

From the Conﬁguration Menu, you can execute the secure command

and preform the subsequent tasks in this section.

To display the current setting for the secure ﬂag, type the following

command at the prompt and press Enter:

Configuration Menu: Enter command > secure

To set the secure ﬂag on, type the following command at the prompt and

press Enter:

Configuration Menu: Enter command > secure on

To set the secure ﬂag off, you need to disconnect the boot disk to

interrupt the boot-up sequence and force the prompt to the Boot Console

Interface. Next, type the following command at the prompt and press

Enter:

Configuration Menu: Enter command > secure off

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 245 246

Pas de commentaire

HP Visualize c3000 Manuel d'instructions Page 196