HP Visualize c3000 Manuel d'instructions Page 213

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 246
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 212
Chapter 7 213
Solving Problems
Troubleshooting Monitor Problems
Troubleshooting Monitor Problems
In the event that your console stops displaying to your graphics device,
use the following procedure to set the console for displaying to an
external terminal.
Here are the steps to follow:
1. Turn system power off.
2. Disconnect the computer keyboard connector from the system rear
panel.
3. Connect a serial terminal to the Serial 1 connector (the left serial
connector) on the system rear panel. Configure the terminal for: 9600
baud, No Stop Bits, No Parity, 8 Bits.
4. Power on the system. The system will now display the console to the
terminal connected to Serial 1 port. Note that you can use a 9-pin to
9-pin serial cable (HP F1044-80002) to connect an HP OminiBook
serial port to the workstation.
5. Set the monitor type and path using the Boot Console Interface. For
information on doing this see the chapter “The Boot Console
Interface” in this document.
Vue de la page 212
1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 245 246

Commentaires sur ces manuels

Pas de commentaire