HP E1351A/53A Manuel d'utilisateur télécharger pdf (Page 20)

Selecting the Interrupt Line Number

The multiplexer module generates interrupts at the end of a downloaded

scan list. The interrupt line number switch determines which backplane

IRQ line will be used. Different mainframes and resource managers

recognize different backplane IRQ lines. The interrupt line number must be

set to the line number your system is programmed to recognize. Refer to

your mainframe manual.

Refer to Figure 2-5 to change the interrupt lines. Valid line numbers are

from 1 to 7. Set the interrupt line number to the mainframe interrupt

handler number.

Figure 2-5. Setting the Interrupt Line Number

20 Configuring the HP E1351A/53A FET Multiplexer Modules Chapter 2

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 106 107

Pas de commentaire

HP E1351A/53A Manuel d'utilisateur Page 20