HP E1351A/53A Manuel d'utilisateur télécharger pdf (Page 21)

Setting the Card ID Switch

The multiplexer module can be an HP E1351A, HP E1352A or HP E1353A

depending on which terminal module is installed. With a normal

connection, the terminal module will automatically configure the module

for the appropriate model. To identify a module without a terminal module,

set the Card ID switch as shown in Figure 2-6. The ID numbers are:

Model Value Configuration

HP E1351A 0 all pins open

HP E1352A 8 pin 3 closed

HP E1353A 2 pin 1 closed

For normal connections, leave the switch at the factory setting which is all

pins open.

Figure 2-6. Card ID Switch

Chapter 2 Configuring the HP E1351A/53A FET Multiplexer Modules 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 106 107

Pas de commentaire

HP E1351A/53A Manuel d'utilisateur Page 21